For more information about these setup requirements, see Installation Methods.Īfter completing this procedure, you will need to perform the post installation tasks as described in Post Installation.ġ.Ğnsure that the installation media is available to boot. An installation method (for example: console, boot media, and install target) should have been chosen and established prior to performing the installation.For further information about these prerequisites, see TABLE 1-2 OS Installation Prerequisites. All applicable installation prerequisites for installing an operating system should have been met.Prior to performing the installation, the following requirements must be met: Note - If you are booting the installation media from a PXE environment, refer to Install Windows Server 2008 via PXE Network for instructions. Windows 2008 ISO image (network repository).Windows 2008 CD or DVD (internal or external CD/DVD).It assumes you are booting the Windows installation media from one of the following sources: The following procedure describes how to boot the Windows Server 2008 operating system from local or remote media. Install Windows Server 2008 Using Local or Remote Media For additional information, consult the Microsoft Windows 2008 Product Documentation at This section walks you through the steps for booting the Windows Server 2008 media, installing drivers (if necessary) at boot, and partitioning the drive. Note - The complete Microsoft Windows operating system installation process is not documented in this section. If required, you can enable the Wake On LAN feature for this server. If necessary, install the updated server-specific drivers and the server supplemental software.Įnable Wake On LAN feature, if appropriate Install driver(s) and supplemental software post installation, if applicable. Install Windows Server 2008 via PXE Network.Install Windows Server 2008 Using Local or Remote Media.You can download or order the media for Windows 2003 at įollow the instructions in this chapter to install the Windows 2008 operating system.The Windows OS is shipped with the CD and DVD media and documentation that you will need to install the Windows OS. Verifying BIOS Settings for New Installations.Verify that the factory default settings in the BIOS are set prior to performing the operating system installation. TABLE 1-2 OS Installation PrerequisitesĮvaluate and select an installation method that meets the needs of your infrastructure.Įnsure that the BIOS factory defaults are set.Verify that all applicable requirements are met for installing an operating system to a server. TABLE 3-1 T ask Map for the Windows Server 2008 Installation The table defines the required tasks, describes them, and provides pointers to the instructions for performing that task. Use TABLE 3-1 to preview the install ation process defined as a series of tasks. You should test that you are able to connect properly from the IP specified, as well as testing to make sure that other connections are being rejected (try to connect from a different workstation or network). If all of the above steps have been completed, your FTP accounts should now be secured by the IP(s) that you specified.Task Map for the Windows Server 2008 Installation.You may also choose to configure the allow rule for A range of IP addresses, however we do not recommend this as it reduces the security of this process. In the Actions pane, click Add Allow Entry. In the Specific IP Address field, enter your desired IP address to allow access to your FTP accounts and click OK.Once this is complete, all connections to your FTP accounts will be blocked (for now). A new window will pop up, allowing you to select Allow or Deny. In the FTP IPv4 Address and Domain Restrictions feature, click Edit Feature Settings in the Actions pane.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |